Civilian routing

How to use an Evac Corridor

Draw a route to a gate, combine it with Hold, and troubleshoot civilians who stop before reaching safety in v0.43.1.

In Planning, choose Civilians → Corridor and drag from the crowd to a reachable Safe Zone Gate. In v0.43.1, the crowd follows the streets around buildings and can enter through the gate at the endpoint.

Draw the corridor to the gate

  1. Before starting the outbreak, open Civilians in the build bar and select Corridor.
  2. Start at a crowd you want to move. Drag toward a reachable gate and release with the corridor endpoint at the entrance. In the current patch, civilians follow streets around buildings toward the endpoint and can go through a gate there.
  3. Check the placement cost in the interface and leave enough budget for the gate and defenses.
  4. After pressing Ready, follow the crowd. Look for people crossing the entrance and a change in Civilians Safe. If the crowd reaches the endpoint without entering, check the last stretch of the route before spending more on its width.
Schematic showing a crowd traveling along a street around a building and ending at the gate in a safe-zone wall
Route sketch: start at the crowd and place the endpoint at the gate. · ZAR Field Guide · diagram

Use Hold to gather a spread-out group

Place a Hold over the area you want to gather. Hold draws nearby civilians from its outer area into the inner area. Start the corridor inside that inner area so people have a route onward. Use Hold when a useful group is spread across nearby streets. A route that already passes through a concentrated crowd may be enough by itself.

Diagnose a stopped crowd

Symptom Check
Nobody joins the line Start where civilians actually are. Use Hold to collect a scattered group.
People reach the end and mill outside Line up the endpoint with a gate. Check whether a building or wall separates the endpoint from it.
People peel off when the infected arrive Civilians avoid danger. Try a safer approach or a closer gate in your next layout.
The price disagrees with an old screenshot v0.43.1 uses a $30 starting fee plus covered area. At default width, the developer gives about $60 for 300 m and $135 for 1 km. Check the current price when changing width.

For the enclosure itself, see safe zones and gates. The patch summary explains why launch-day corridor tutorials quote a different price.

Sources & verification